Characteristics and maintenance of safety valve

1、 Key types and structural features of safety valves:

 

The safety valve is a kind of fully automatic valve, which can be fully opened under the condition of overpressure of mechanical equipment, and discharge unnecessary substances, so as to ensure the safety of mechanical equipment. When the working pressure drops to the standard value, it can be fully closed and repaired, and prevent the further outflow of substances. There are many types of safety valve, the key is static weight type, rod type and spring type. Among them, the main use of spring type safety valve is more common. Here is a key introduction to spring type safety valve. As we all know, the tighter the spring is pressed, the greater the force is needed. In other words, the clamping force of the spring is positively related to the shape variable. With the increase of the height width ratio of the valve core opening, the reduction of the spring is also increased, and the recoil force is relatively expanded, which is just the force that the safety valve must bear in the work. There are many types of spring type safety valves. Nowadays, the key choice is cylindrical spiral, and the cross section of stainless steel wire is generally annular reducing spring. This kind of spring has typical linear bearing characteristics, which conforms to Hooke's law.

 

2、 Application, maintenance and common problems of safety valve:

 

Before installation and application, the safety valve should be adjusted to the required working pressure on the test bench, and the tightness of the safety valve should be checked. The adjusted and checked safety valve should be sealed. The safety valve in application should be maintained regularly, and checked on time according to the relevant safety production technical supervision technical specifications. The common faults of safety valve and the key ways to remove them are as follows:

 

1. Valve leakage: under all normal pressure of the valve, the protruding surface of the valve core and the high-pressure gate valve has leakage beyond the allowable level. Key reasons and solutions:

 

1) If the dirt falls into the convex surface, the valve can be opened several times with the lifting wrench to flush the dirt away.

 

2) Protrusion damage. According to the damage level, grinding or milling after milling should be used to repair in many aspects.

 

3) If the spring is loose, the setting pressure will be reduced and the valve will leak. The spring should be replaced or the screw of the extruder should be properly tightened.